Used for soft, delicate works in order to remove burrs, as well as for smoothing roughness, polishing, removal of scale, rust, old paint, and for the treatment of non-metal surfaces. A distinctive feature of the blast machine is small consumption of compressed air. Stable operation without ripples is achieved in the presence of compressed air in a volume of 0,8 m3/min at a pressure of 5,07-8,11 bar.
AREA OF APPLICATION
It is mobile and easy to operate. It is widely used in car workshops, restoration workshops, in the production of joinery and glassware.
ABRASIVE MEDIA
Supplied with Sandsturm® multipurpose abrasive metering valves, which allow working with any common abrasives 0.2 to 1.6 mm grade: cast-iron and steel shot and grit, marble and granite chips, glass beads, aluminum oxide, silicon carbide, alundum, copper and nickel slag and other kinds of media fabricated specially for blasting.
It comes fully stocked and ready for use. It is must be connected to a source of compressed air to start working.
Equipped with a special injection device “iD”, which is designed for receiving abrasive material and adjusting underpressure, which is used for the abrasive material to be fed into the suction gun through a hose.
For tuning and watching of pressure.
The sieve is located inside that reduces the overall height of the blast machine and makes it easier to load it with abrasive. A thick perforated metal sheet with openings of 4 mm is used as a sieve. A perforated sieve is more effective for screening abrasive material than a sieve made of wire mesh. It protects the blast machine from particles more than 4 mm diameter and different types of debris that prevent uninterrupted operation of the equipment. To protect the device, they use a lightweight metal edge-raised cover, the edges of which hang over the walls of the setting and prevents the passage of moisture into the machine.